Ribimex RIBILAND PREHLS52N Guide D'utilisation Et Manuel D'instructions page 26

10. Do not overreach
Keep proper footing and balance at all times.
Floor must not be slippery.
Never stand on log or log splitter. Serious injury could occur if the tool is tipped or if the cutting tool
is unintentionally contacted.
Do not store anything above or near the log splitter where anyone might stand on the tool to reach
them.
11. Maintain product with care
Keep product clean for better and safer performance.
Follow instructions for lubrication and changing accessories.
Keep handles dry, clean and free from oil and grease
12. Disconnect (switch off) product when not in use, before servicing and when changing
accessories.
13. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and adjusting wrenches are removed from the product
before starting it.
14. Avoid unintentional starting
Ensure switch is off before starting.
15. Stay alert
Watch what you are doing. Use common sense.
Never operate this machine or any other power equipment if you are tired, ill, or
under the influence of alcohol, drugs, or any other substance that could affect
your ability of judgment to use it properly.
16. Check damaged parts
Before further use or reuse of the product, it should be carefully checked to determine that it will
operate properly and perform its intended function.
Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and
any other conditions that may affect its operation
17. Do not abuse the power cable
Never carry the tool by the cable or yank it to disconnect it from the socket.
Keep the cable away from heat, oil and sharp edges.
Inspect tool cable periodically and if damaged have it repaired by an authorized service facility.
18. Use of extension leads
Do NOT use cable reels.
When tool is used with extension cord, ensure that extension cord withstands tool ratings.
If used outdoors, use only extension cords intended for outdoor use. Fully extend the extension cord.
Improper use of extension cords may cause inefficient operation of the log splitter which can result in
overheating. Be sure the extension cord is no longer than 10m and its section is no less than 2.5mm
allow sufficient current flow to the motor. Avoid use of free and inadequately insulated connections.
Connections must be made with protected material suitable for outdoor use.
Inspect extension cords periodically and replace, if damaged.
19. Defective switches or other part that is damaged should be properly repaired or replaced by an
authorized service centre. Do not use the product if the switch does not turn it on and off.
20. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual,
may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
21. Have your product repaired by qualified personnel
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorised service centre is recommended.
2
to
Page 26 / 59