Safety Notes - IMG STAGELINE TXS-900 Mode D'emploi

Receiver for a Wireless Microphone
These instructions are intended for users without
any specific technical knowledge . Please read these
instructions carefully prior to operation and keep
them for later reference .
All operating elements and connections de-
scribed can be found on the fold-out page 3 .
1 Overview
1 Receiving antennas
2 Button POWER to switch the receiver on / off
(keep button pressed for approx . 1 second)
3 Button SYNC to synchronize the receiver and
the transmitter: While keeping the synchroni-
zation button pressed on the transmitter [SYNC
(D) starts flashing on the display], briefly press
the button SYNC on the receiver . Thus, the
transmitter is set to the transmission channel
of the receiver .
4 Display ( ☞
fig . 3)
A indication of operating mode
"MANUAL" manual frequency setting
(in steps of 25 kHz)
"SCAN" channel scan
"PRESET" selection of a channel from one
of 4 preset groups (8 channels
in each group)
Use the button
sired mode (keep button pressed for approx .
1 second) .
B in the mode PRESET: indication of group
("P1" ... "P4")
C in the mode PRESET: indication of channel
number ("1" ... "8") within the group
D indication "SYNC" for synchronizing the
re ceiver and the transmitter:
☞
button SYNC (3)
E indication of channel number
F indication "MUTE"; to indicate muting of
the audio outputs when settings are made
via the buttons SET,
the button POWER (2) is pressed
G indication of radio frequency
H bargraph "RF" (radio frequency) for the
strength of the radio signal received
I bargraph "AF" (audio frequency) for the
volume of the audio signal received
or to select the de-
 
and (5) or when
 
5 Buttons SET, and

channel in the operating mode selected:
☞
chapter 7
6 Volume control for the output signal of the
receiver
7 Antenna inputs A and B (BNC jacks)
8 Audio outputs, each for connection to a micro-
phone input or a line input, e . g . of a mixer or
an amplifier
– XLR chassis plug, balanced
– 6 .3 mm jack, unbalanced
9 Level selector switch for the audio outputs (8),
to match the output level to the input of the
audio unit connected
MIC for connection to a microphone input
LINE for connection to a line input
10 Control to adjust the squelch threshold
11 Power supply jack to connect the power supply
unit provided
2

Safety Notes

The units (receiver and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING The power supply unit uses danger-
ous mains voltage . Leave servicing
to skilled personnel only . Inexpert
handling may result in electric
shock .
•
The units are suitable for indoor use only . Protect
them against dripping water and splash water,
high air humidity and heat (admissible ambient
temperature range: 0 – 40 °C) .
•
Immediately disconnect the power supply unit
from the mains socket
1 . if the receiver or the power supply unit is vis-
ibly damaged,
2 . if a defect might have occurred after a unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the units must be repaired by skilled
personnel .
•
For cleaning only use a dry, soft cloth; never use
water or chemicals .
•
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used
for other purposes than originally intended, if
to set the transmission

.
9