Operating Elements And Connections; Safety Notes; Applications - IMG STAGELINE TXS-800 Mode D'emploi

Please take out page 3. Then you can always
GB
see the operating elements and connections de-
scribed.

1 Operating Elements and Connections

1 Power LED
2 Reception LED
3 Overload LED AF PEAK [independent of the
volume control AUX VOLUME (8)]
4 Power switch
5 Connection SUPPLY 12 V
ply unit (11) [supplied with the receiver]
6 Antenna,
models TXS-840 and TXS-842 are provided with
two antennas
7 SQUELCH control for adjusting the threshold for
interference suppression
8 Volume control AUX VOLUME for the output level
of jack AUX (9)
9 6.3 mm output jack AUX for connecting to a micro-
phone input or a highly sensitive line input of a
mixer or amplifier
10 XLR output BAL MIC for connecting a balanced
microphone input of a mixer or amplifier
11 Plug-in power supply unit
12 Low voltage plug of the power supply unit for
connection to the jack SUPPLY 12 V
receiver

2 Safety Notes

The units (receiver and plug-in power supply unit) cor-
respond to the directive for electromagnetic compati-
bility 89/336/EEC. The plug-in power supply unit also
corresponds to the low voltage directive 73/23/EEC.
WARNING The plug-in power supply unit is sup-
plied with hazardous mains voltage
(230 V~). Leave servicing to skilled per-
sonnel only. Inexpert handling may
cause an electric shock hazard.
Always observe the following items:
The units are suitable for indoor use only. Protect
them against dripping water and splash water, high
air humidity and heat (admissible ambient tempera-
ture range 0 – 40 °C).
Even with the receiver switched off, the plug-in
power supply unit connected to the mains supply
has a low current consumption.
Do not operate the receiver and immediately dis-
connect the plug-in power supply unit from the
mains socket
1. if there is visible damage to the plug-in power
supply unit or to the receiver,
2. if a defect might have occurred after the unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled per-
sonnel.
6
for plug-in power sup-
(5) of the
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the units are used for other pur-
poses than originally intended, if they are not cor-
rectly connected, operated, or not repaired in an
expert way.
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to
the environment.

3 Applications

In combination with a wireless microphone, the re-
ceiver TXS-8... makes up a wireless microphone
system. This system allows wireless transmission of
music and speech from the microphone to the re-
ceiver. The range is approx. 30 m and depends on
local condi-tions.
The receiver is available in two types and for two
different transmission channels (transmission frequen-
cies) each:
Model Frequency
TXS-800 863.05 MHz
TXS-802 864.80 MHz
TXS-840 863.05 MHz
TXS-842 864.80 MHz
* Diversity technique: Two antennas receive the transmitted
signal separately. The respective more powerful antenna sig-
nal is then internally switched to the input of the receiving
part.
When using two microphone systems with different
frequencies, signals from two microphones can be
transmitted on different channels. It is possible to com-
bine e. g. the following wireless microphones from the
"img Stage Line" range with the TXS-8.. receivers:
Type
Hand-held microphone
with integrated trans-
mitter
Pocket transmitter for
headband microphone
HSE-100
Pocket transmitter with
tie-clip microphone
Pocket transmitter with
headband microphone
Type
Diversity*
Diversity*
suitable for suitable for
TXS-800 TXS-802
TXS-840 TXS-842
TXS-820HT TXS-822HT
TXS-820HSE TXS-822HSE
TXS-820LT TXS-822LT
TXS-820SX TXS-822SX