EUROM Safe-t-Convect 2200 Manuel D'utilisation page 20

 Pressing on the Output button (1) several times allows you to set another output:
900W→1300W→2200W
 750W→1250W→2000W). When heating, you can switch on air circulation using
the ventilator button (5); this will ensure the heat is distributed quicker. Pressing
this button again will switch the fan off.
 Pressing on the output button once again will turn on the frost-protection setting:
the thermostat will set to 7°C automatically, the frost icon will appear and if the fan
was on, this will switch off. If the temperature falls under 5°C, the device will start
to work on low power.
 If you press the output button again, the device will switch back to 900W
(Switzerland: 750W) without fan option and the process will repeat.
 You can use the higher/lower buttons (6 and 7) to increase/decrease the set
temperature. The device has a thermostat and will provide heat until the set
temperature is reached. The temperature will then be maintained; the device will
switch itself back on automatically if the temperature drops by 2°.
 The number of hours the device stays on can be set using the timer button. 1x
press = 1 hr, 2x presses = 2 hrs and so on until max. 15 hours. The display will
show the set number of hours. Pressing this button again will switch the timer off.
 Pressing the Celsius↔Fahrenheit button will change the display from ºC to ºF and
vice versa.
 Press the stand-by button again in order to switch off. Then press the ON/OFF
switch to OFF and remove the plug from the socket.
is at least 2° higher than the current temperature (left on the display)!
Safety features
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning, but
have it inspected/repaired!
In case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially) covering
the heater, obstructing the air intake and/or outlet grills or installing the heater too
close to a wall or something similar. When the heater has cooled down sufficiently, it
will in principle start again automatically, however if you do not remove the cause of
the cut-off then this will probably be repeated. Regular overheating can give rise to
irreparable damage. In case of overheating, switch off the heater and unplug. Give
the heater time to cool down, remove the source of the overheating and use as
normal. If the problem persists or if you have not been able to trace the source of the
overheating, turn the heater off immediately and unplug. Contact a servicing point to
have the heater repaired.
NB: the device will only provide heat
if the set temperature (right on the display)
20
(Switzerland: