EUROM Safe-t-Convect 2200 Manuel D'utilisation page 19

Attach the feet supplied to the underside of the heater:

Turn the heater upside down. Place a blanket (or something similar) under the
heater to prevent damage!

Slide the feet from the side so that the grooves go as far as they can over the
protruding brackets; this will ensure that the threaded holes will align correctly.

Securely attach the feet to the heater using the short self-tapping screws.

Return the heater to the upright position.

Choose a suitable location for the heater which is at least one metre away from
any obstructions, walls or inflammable materials (see also safety instructions).

Make sure a functioning heater is always placed on a solid, flat and horizontal
surface.

Check if the ON/OFF switch (D) is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V socket. Only
connect the heater to an earthed socket! To prevent the circuit overloading, check
that no other appliances are connected to the same group.
Set-up and Operation
1. Output button
2. Celsius↔Fahrenheit button
3. Receiving point – remote control
4. Stand-by button
Set the ON/OFF switch (D) to 'ON' (I). The display shows the current temperature
(left) and the set temperature (right) which is 25°C as standard. The device is now in
stand-by.
You can now operate the device using the buttons on the display or the remote
control. Both offer the same buttons. If you are using the remote-control, point it
towards the receiving point (3) on the device.
 Start the device by pressing the stand-by button (4). The device will select the
function 'heat at low power'. 900W (Switzerland 750W). If the set temperature is 2
degrees higher than the current temperature, the device will heat the space as a
convector.
5. Ventilator button
6. Higher button
7. Lower button
8. Timer
19