Concluding Tasks; Operation; Authorisation - Mennekes Premium 22 Série Mode D'emploi

6.4 Concluding tasks

After installation and setting-up process, you must carry
out the following steps:
1
2
Fig. 13: Close the device
f Replace the two covers above and below.
f Retighten the four screws below the front panel.
f Close the front panel.
f Lock the front panel.
f Pull the key out of the cylinder lock.
f Remove all protective foil.

7. Operation

7.1

Authorisation

Depending on the configuration, using the device may
require prior authorisation. The following options are avail-
able:
„ No authorisation is required. All users can charge.
„ All users with an RFID card can charge.
„ All users whose RFID card is activated can charge.
„ Authorisation is dependent on a backend system, for
example with a smartphone app or ad hoc (e.g. direct
payment).
f Follow the directions on the plain text display.
f Follow the directions on the device (e.g. scan QR code).
9 The data are checked.
9 The authorisation was successful. The charging process
can now be started.
If charging does not start within the release time,
the authorisation is reset, the charging sock-
ets are locked and the device switches to the
"Standby" mode. A new authorisation is required.
If the authorisation process is not completed, there may
exist a fault.
Î "9. Troubleshooting"
EN
13