Nylon Cutting Head; Installing The Handle - Makita DUR187U Manuel D'instruction

Indicator
Reverse button for debris removal
WARNING:
Switch off the tool and remove
the battery cartridge before you remove entan-
gled weeds or debris which the reverse rotation
function can not remove. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris entan-
gled in the tool.
To reverse the rotation, tap the reverse button and pull
the trigger when the tool's head is stopped. The power
lamp starts blinking, and the tool's head rotates in
reverse direction when you pull the switch trigger.
To return to regular rotation, release the trigger and wait
until the tool's head stops.
► 1. Reverse button
NOTE: During the reverse rotation, the tool operates
only for a short period of time and then automatically
stops.
NOTE: Once the tool is stopped, the rotation returns
to regular direction when you start the tool again.
NOTE: If you tap the reverse button while the tool's
head is still rotating, the tool comes to stop and to be
ready for reverse rotation.
Mode Rotation speed
Auto 4,000 - 6,000 min
High 6,000 min
Medium 5,000 min
Low 4,000 min

Nylon cutting head

-1
Optional accessory
NOTICE:
-1
the head is not rotating.
-1
-1
► 1. Most effective cutting area
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed out the nylon cord, tap the cutting head against
the ground while rotating.
NOTE: If the nylon cord does not feed out while tap-
ping the head, rewind/replace the nylon cord by follow-
ing the procedures described under "Maintenance".
ASSEMBLY
WARNING:
and battery cartridge is removed before carrying out any work
on the tool. Failure to switch off and remove the battery cartridge
may result in serious personal injury from accidental start-up.
WARNING:
assembled. Operation of the tool in a partially assembled state
may result in serious personal injury from accidental start-up.

Installing the handle

1
For DUR187U and DUR188U only
1. Insert the shaft of the handle into the grip. Align the screw
hole in the grip with the one in the shaft. Tighten the screw securely.
2
► 1. Grip 2. Screw 3. Handle
9 ENGLISH
The bump feed will not operate properly if
Always be sure that the tool is switched off
Never start the tool unless it is completely
3
1
1