Makita DUR187U Manuel D'instruction page 14

DUR187L and DUR188L
1
► 1. Hook 2. Hanger
Detachment
The shoulder harness features a means of quick
release.
DUR187U and DUR188U
1
► 1. Strip
Pull out the strip release the tool from the shoulder
harness.
DUR187L and DUR188L
1
► 1. Buckle
Simply squeeze the sides of the buckle to release the
tool from the shoulder harness.
2
MAINTENANCE
WARNING:
switched off and battery cartridge is removed
before attempting to perform inspection or main-
tenance on the tool. Failure to switch off and remove
the battery cartridge may result in serious personal
injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Replacing the nylon cord
WARNING:
specified in "SPECIFICATIONS" only. Never use
heavier line, metal wire, rope or the like. Use rec-
ommended nylon cord only, otherwise it may cause
damage to the tool and result in serious personal
injury.
WARNING:
nylon cutting head is secured to the housing
properly as described below. Failure to properly
secure the cover may cause the nylon cutting head to
fly apart resulting in serious personal injury.
1. Press on the housing latches inward to lift off the
cover, then remove the spool.
1
► 1. Latch 2. Cover
2. Prepare approximately 3 m (9 ft) of new nylon
cord. Fold the new nylon cord with one end become
approximately 80 mm (3-1/8") longer than the other
end. Then hook the new nylon cord into the notch in the
center of the spool.
Wind both ends firmly around the spool in the direction
of the head rotation (left-hand direction indicated by LH
on the side of the spool).
14 ENGLISH
Always be sure that the tool is
Use nylon cord with diameter
Make sure that the cover of the
2
1