Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
80 mm (3-1/8")
► 1. Spool
3.
Wind all but about 100 mm (3 - 15/16") of the
cords, leaving the ends temporarily hooked through a
notch on the side of the spool.
4.
Mount the spool in the housing so that the grooves and
protrusions on the spool match up with those in the housing.
Keep the side with letters on the spool visible on the top. Now,
unhook the ends of the cord from their temporary position and
feed the cords through the eyelets to come out of the housing.
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-
ment parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
It does not reach maximum RPM.
1
100 mm (3-15/16")
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
15 ENGLISH
► 1. Spool 2. Housing 3. Eyelet
5.
Align the protrusion on the underside of the cover
with the slots of the eyelets. Then push the cover firmly
onto the housing to secure it.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using of tool to allow it to cool down.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
1
2
3
Publicité
Table des Matières
