MICRO MEGA STATIS SL 101.1 Manuel De L'opérateur page 30

5 Operation
Disconnecting:
Hold the coupling and pull off the turbine while turning it slightly in an axial direction.
Diamond and Carbide Use:
Only use burs that have shafts compliant with ISO 1797-1 type 3, made from steel or tungsten carbide and that meet the following
criteria:
Shaft diameter from 1.59 - 1.60 mm
•
Overall length up to max. 25 mm
•
Shaft clamping length of at least 11 mm
•
Cutting edge diameter up to max. 2 mm
•
Short shank burs are recommended for the turbine STATIS SL model 101.1
•
Ensure that the product is used for its intended purpose only and in compliance with the manufacturer's instructions. Burs that do not
meet the above criteria must not be used. Never use burs with worn shafts as these may drop out during treatment, causing injury.
Inserting the bur:
Press the push-button firmly with the thumb. At the same time, insert the bur as far as it will go. Check the function of
the chuck by pulling on the bur. Use gloves or another type of finger protection to test, insert and remove in order to
avoid any risk of injury and infection.
Page 28
®
MICRO-MEGA - STATIS