Use Of Dishwasher Salt - Atag VA6311LT Notice D'utilisation

24
German degrees
(°dH)
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
You must adjust the water softener
manually and electronically.
Manual adjustment
Turn the water hardness dial to the position
1 or 2 (refer to the table).
Electronic adjustment
1. Activate the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold the programme button
until the programme indicator (A) starts

Use of dishwasher salt

How to fill the salt container:
1. Turn the cap counterclockwise and
open the salt container.
2. Fill the salt container with 1 litre of wa-
ter (only for the first time you fill with
salt).
3. Use the funnel to fill the salt container
with salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
Water hardness
French degrees
(TH°)
33 - 39
26 - 32
19 - 25
7 - 18
< 7
mmol/l Clarke de-
grees
3,3 - 3,9 23 - 27
2,6 - 3,2 18 - 22
1,9 - 2,5 13 - 17
0,7 - 1,8 5 - 12
< 0,7 < 5
to flash and the programme indicator (B)
comes on.
4. When the programme indicator (B) goes
off and the end indicator starts to flash,
press the programme button. The pro-
gramme indicator (A) continues to flash.
The electronic adjustment of the water
softener is activated.
5. The end indicator shows the setting of
the water softener. The number of flash-
es of the end indicator is the same as
the water hardness level (example: 5
flashes / pause / 5 flashes = level 5).
6. Press the programme button to change
the adjustment. Press the programme
button again and again to change the
setting. When the programme button is
pressed, the level number increases.
7. Deactivate the appliance to confirm.
If the water softener is set electronically
to the level 1, the salt indicator stays
off.
It is correct that water comes out from
the salt container when you fill it with
salt.
Water hardness ad-
justment
manually elec-
troni-
cally
1) 1)
2 5
1 4
1 3
1 2
2) 2)
1 1