Before First Use - Atag VA6111MT Notice D'utilisation

If one or more options are set, make
sure that the related indicators are on
before the programme starts.
Multitab function
Activate this function only when you use the
combi detergent tablets.
This function deactivates the flow of rinse
aid and salt. The related indicators are off.
The programme duration can increase.
Activating the multitab function
Activate or deactivate the multitab
function before the start of a pro-
gramme. You cannot activate or deac-
tivate this function while a programme
operates.
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
2. Press the multitab button, the multitab
indicator comes on.
The function stays on until you deacti-
vate it. Press the multitab button, the
multitab indicator goes off.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener. Contact your local water au-
thority to know the water hardness in
your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
Acoustic signals
The acoustic signals operate in these con-
ditions:
• The programme is completed.
• The level of the water softener is adjusted
electronically.
• The appliance has a malfunction.
Factory setting: on. You can deactivate
the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
2. Press and hold function buttons (B) and
(C) at the same time until the indicators
of function buttons (A), (B) and (C) flash.
3. Press function button (C),
• The indicators of function buttons (A)
and (B) go off.
• The indicator of function button (C)
continues to flash.
• The display shows the setting of the
acoustic signals.
4. Press function button (C) to change the
setting.
5. Deactivate the appliance to confirm.
4. Open the water tap.
5. Processing residues can stay in the ap-
pliance. Start a programme to remove
them. Do not use detergent and do not
load the baskets.
If you use the combi detergent tablets,
activate the multitab option.
19
On
Off