Acoustic Signals; Before First Use; Adjusting The Water Softener - Atag VA4611AT Mode D'emploi

flashes quickly 3 times and then goes
off.
Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse aid
and salt. The related indicators are off.
The programme duration can increase.
• Press the multitab button, the related in-
dicator comes on.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse aid.

Acoustic signals

The acoustic signals operate in these con-
ditions:

BEFORE FIRST USE

1. Make sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener. Contact your local water au-
thority to know the water hardness in
your area.
2. Fill the salt container.

Adjusting the water softener

German
degrees
(°dH)
51 - 70
43 - 50
37 - 42
29 - 36
Water hardness
French mmol/l
degrees
(°fH)
91 - 125 9.1 - 12.5
76 - 90 7.6 - 9.0
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
• The programme is completed.
• The level of the water softener is adjusted
electronically.
• The appliance has a malfunction.
Factory setting: on. You can deactivate
the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
2. Press and hold buttons (4) and (5) at the
same time until the indicators of buttons
(3), (4) and (5) flash.
3. Press button (5),
• The indicators of buttons (3) and (4)
go off.
• The indicator of button (5) continues
to flash.
• The display shows the setting of the
acoustic signals.
4. Press button (5) to change the setting.
5. Deactivate the appliance to confirm.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the ap-
pliance. Start a programme to remove
them. Do not use detergent and do not
load the baskets.
Clarke
degrees
64 - 88
53 - 63
46 - 52
36 - 45
21
On
Off
Water softener
adjustment
Manual Elec-
tronic
1) 10
2
1) 9
2
1) 8
2
1) 7
2