What To Do If - Atag VA6311LT Notice D'utilisation

3. Fully clean the parts with water.
4. Put the two parts of the filter (A) togeth-
er and push. Make sure that they as-
semble correctly in each other.
5. Remove the filter (B).
6. Fully clean the filter (B) with water.
7. Put the filter (B) to its initial position.
Make sure that it assembles correctly in
the two guides (C).

What to do if...

The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
• The programme indicator flashes continuously.
• The end indicator flashes one time intermittently.
• The programme indicator flashes continuously.
• The end indicator flashes two times intermittently.
Alarm code
8. Put the filter (A) into position in filter (B).
Turn the filter (A) clockwise until it locks.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (acetone).
With some malfunctions the indicators
flash to show an alarm code.
The appliance does not fill with water.
The appliance does not drain the water.
Malfunction
31