Settings
A - Activating or deactivating the cleaning
function
The actuator plate and WC can be cleaned without
triggering a flush.
Prerequisites
The WC flush control is ready for operation.
If the sensors are not covered at the same time, a
flush will be activated. Remove your hands and
repeat the procedure.
1
Cover both sensors at the same time with both
hands at a distance of approx. 5 cm. After a few
seconds both sensors begin to flash. Now
remove both hands.
Result
The cleaning function is now active.
The cleaning function is automatically deactivated
after 3 min.
2
Now carry out the cleaning process. Remember
to follow the care instructions provided in these
operating instructions.
3
Cover both sensors at the same time with both
hands at a distance of approx. 5 cm to deactivate
the cleaning function. The flashing stops after a
few seconds. Now remove both hands.
Result
The cleaning function is deactivated. The WC
flush control is ready for operation again.
14
B - Selecting the colour of the sensor lights
The following colours can be selected:
Blue, turquoise, magenta, orange, yellow
Prerequisites
The WC flush control is ready for operation.
If the sensors are not covered at the same time, a
flush will be activated. Remove your hands and
repeat the procedure.
1
Cover both sensors at the same time with both
hands at a distance of approx. 5 cm. After a few
seconds both sensors begin to flash. After a few
more seconds, the sensors flash red 3 times and
then turn blue. Now remove both hands.
Result
You are now in the mode for setting the colour of
the sensor lights.
2
Place your hand in front of the sensor on the right.
The next colour appears on both sensors.
3
Place your hand in front of the sensor on the right
repeatedly until the desired colour is displayed.
4
Cover both sensors at the same time with both
hands at a distance of approx. 5 cm until both
sensors flash once.
Result
The desired light colour is now saved. The WC
flush control is ready for operation again.