Table des Matières
Publicité
C - Adjusting the sensor illumination
Three different settings are possible.
1. The sensor illumination always remains off and does
not come on even when you approach the WC
2. The sensor illumination always remains on, even
when you step back from the WC and leave the
room
3. The sensor illumination comes on as soon as you
approach the WC and goes off again when you step
back
Prerequisites
The WC flush control is ready for operation.
If the sensors are not covered at the same time, a
flush will be activated. Remove your hands and
repeat the procedure.
1
Cover both sensors at the same time with both
hands at a distance of approx. 5 cm. After a few
seconds both sensors begin to flash. After a few
more seconds, the sensors flash red 3 times and
then turn blue. Now remove both hands.
2
Cover the sensor on the left with your hand until it
lights up orange. The sensor on the right flashes
repeatedly to show the current setting
(setting 1 = flashing once, setting 2 = flashing
twice, setting 3 = flashing three times).
Result
You are now in the setting mode for the sensor
illumination.
3
Cover the sensor on the right repeatedly until the
desired setting has been made. Each time you
cover the sensors, the WC flush control jumps to
the next setting (1-2-3-1-2-3- ...).
4
Cover both sensors at the same time with both
hands at a distance of approx. 5 cm until both
sensors flash once.
Result
The desired setting is now saved. The WC flush
control is ready for operation again.
Settings
DE
EN
FR
IT
NL
ES
PT
DK
NO
SE
FI
IS
PL
HU
SK
CZ
SL
HR
SR
EE
LV
LT
BG
RO
GR
TR
RU
AE
CN
JP
15
Publicité
Table des Matières
