Medela Invia White Foam Mode D'emploi page 12

Step 2 – Apply transparent film
a) Peel the central
layer "1"
Film should extend 3–5 cm beyond wound margin to facilitate adequate seal.
Film should be securely anchored to periwound area to maintain an air tight seal.
Film can be cut into multiple pieces for easier handling, Make sure to retain a portion
of the handling bars on each piece.
Step 3 – Cut hole in the film
Step 4 – Attach the suction pad (FitPad)
12
2
2
2
2
2
2
2
b) Place the adhesive
face down over the
foam and remove
side layers "1"
Select an appropriate location over the dressed wound bed for the
suction pad (FitPad) to be applied and pinch the transparent film over
the area lifting slightly.
Cut a small hole in the pinched area (approx. 1 cm diameter).
Peel off the backing of the suction pad.
Center the suction pad over the previously cut hole in the dressed
wound and apply by pressing firmly for adherence.
Pay attention to tubing positioning to allow for optimal flow: avoid
placement over bony prominences.
c) Peel top layer "2"
¨
d) Detach handling
bars along
perforated lines