Error Displays/Messages - Sony DSX-S300BTX Mode D'emploi

A call is answered unintentionally.
• The connecting phone is set to start a call
automatically.
• "Auto Answer" of this unit is set to "Short" or
"Long" (page 33).
Pairing failed due to time out.
Depending on the connecting device, the time limit for
pairing may be short. Try completing the pairing
within the time.
Bluetooth function cannot operate.
Turn off the unit by pressing (SOURCE/OFF) for 2
seconds, then turn the unit on again.
No sound is output from the car speakers
during handsfree call.
If the sound is output from the cellular phone, set the
cellular phone to output the sound from the car
speakers.
The external microphone does not work.
The setting of the microphone is not correct.
48

Error displays/Messages

Busy now... Please try later
This unit is busy.
t After waiting a moment, try again.
Checking
The unit is confirming the connection of a USB device.
t Wait until confirming the connection is finished.
Connection Failed
Accessing the phonebook was terminated from the
cellular phone.
t Access the phonebook in the cellular phone again.
Device Inside
If you turn the ignition switch to the OFF position
without removing the USB device or iPod, "Device
Inside" will appear in the display.
Empty
• The call history is empty.
• The phonebook is empty.
Error
• USB device was not automatically recognized.
t Reconnect it again.
• Phonebook content was changed while accessing the
cellular phone.
t Access the phonebook in the cellular phone again.
Failure (Illuminates until any button is pressed.)
The connection of speakers/amplifiers is incorrect.
t See the installation guide manual of this model to
check the connection.
Failure (Illuminates for about 1 second.)
When the SAT tuner is connected, storing an SAT
radio channel into a preset failed.
t Be sure to receive the channel that you want to
store, then try it again.
HF Device is not available
A cellular phone is not connected.
t Connect to a cellular phone.
Hubs Not Supported
USB hub is not supported on this unit.
Invalid channel file
A file in the music folder may have been edited
without using "Content Transfer."
t Perform "SensMe™ Setup" for the USB device or
Walkman again. For details on "SensMe™ Setup",
see page 22.
Local Seek +/–
The local seek mode is on during automatic tuning.
NO Device
USB is selected as source without a USB device
connected. A USB device or a USB cable has been
disconnected during playback.
t Be sure to connect a USB device and USB cable.
NO Music
The USB device does not contain a music file.
t Connect a USB device with a music file in it.
NO Name
An album/artist/track name is not written in the track.