Viscount UNICO 500 Guide De L'utilisateur page 59

Viscount
User Guide
UNICO 500 - 400 - 300
9.1 SETTING THE ROUTING OF THE VOICES ON THE REAR AUDIO
OUTPUTS (EXT. OUT ROUTER function)
One of the Unico series organs' key features is the capability for simulating the position of the wind-chests
and the arrangement of the pipes inside them, for every stop. This is achieved by setting the routing of the
audio signals, i.e. the way in which they are distributed, on the rear outputs. For each stop, the system is able
to set an output configuration which reflects the layout of the pipes in real wind-chests, as follows:
- single or double cusp
- double wing
- left or right wing
- mono
- alternate keys
Moreover, each of these layouts can be further specified with regard to the width of the wind-chest and its
location in space, defined by the number of outputs used. To access the rear audio output setting video page,
select the EXT. OUT ROUTER field in the SET-UP menu:
Unico 300
Unico 500 and 400
this displays the screen for selection of the section which contains the stop to be set up, which has to be
chosen from the list of the stops in the section:
Here again, there is the option of displaying the set-up screen directly by holding out the draw-stop or
holding down the rocker tab for a few moments in the voice on position with the cursor on the EXT. OUT
ROUTER field in the SET-UP menu, or in the function itself.
The LED of the stop being set up will flash to prevent modification errors; the stop will be on and can be
played for better, quicker adjustment. Other stops can also be switched on to assess the overall effect of the
changes.
57