Télécharger Imprimer la page

Viscount UNICO 500 Guide De L'utilisateur page 49

Masquer les pouces Voir aussi pour UNICO 500:

Publicité

Les langues disponibles

Les langues disponibles

User Guide
-
[32' REED REVERS.]: switches off the 32' reeds.
26. Rear connections.
On the back of the organ, there are various connections for making the audio connection to external
speaker systems, and the line and microphone input for use of the organ's internal amplifier.
-
[EXT. +12V DC] connectors: power at +12 Volt can be obtained from these connectors to switch-
on any VISCOUNT speakers connected to the PROG. OUT. outputs.
-
OUT [GEN. SUB] (General Sub-Woofer): dedicated output for the connection of low-frequency
speakers (sub-woofer).
-
PROG. OUT (Programmable Outputs): the instrument's general line outputs, allowing simulation of
the wind-chests of pipe organs. The signals are distributed over the outputs on the basis of the
display function settings, which allow setting of the type of wind-chest, its size and the position in
space of the speakers used, for each stop. Each output also has dedicated level and equalisation
controls.
-
INPUT [L(+R)] / [R]: line inputs which allow other instruments to be played using the organ's
internal amplification. If the source is monophonic use the [L+(R)] connector only.
-
INPUT [MIC]: microphone input allowing amplification of the signal from a microphone.
-
[GAIN]: trimmer for regulating the gain of the input signal received at the [MIC] connector.
WARNING!
This group of connections on the rear is not visible from the outside and the organ's wooden rear
panel has to be removed to access it. Contact qualified staff for this procedure.
Viscount
47
UNICO 500 - 400 - 300

Publicité

loading

Ce manuel est également adapté pour:

Unico 400Unico 300