Viscount UNICO 500 Guide De L'utilisateur page 60

Viscount
UNICO 500 - 400 - 300
the screen comprises four sections:
o MODE: selects the type of wind-chest from:
- C – C# (alternate keys)
- MONO
- DOUBLE CUSP
- CUSP
- DOUBLE WING
- WING
o FROM and TO: they select the limits of the area, set in outputs, within which the wind-chest is to be
located. The value is set as [output number-position between two outputs], bearing in mind that there are
four positions between one output and the next (2-4-6-8 on the display).
A value of 40 means that the end of the range (FROM or TO) is on output [4]; a value of 82 means that
the FROM or TO point is between output [8] and [9], close to [8] since it is in the first fifth of the area
between output [8] and output [9]. The screen previosly shown refers to a peaked wind-chest placed
between output [1] and a position between outputs [4] and [5].
o [position indicator]: it consists of small rectangles located above the drawing of the wind-chest and
indicates that the zone is displaying the part below the total number of outputs.
o [wind-chest on outputs]: in the bottom of the screen, it provides a graphic illustration of the wind-
chest with the references to the outputs being used, to give an immediate picture of its position and the
outputs which will carry the notes, in accordance with the wind-chest configuration.
To view the setup of another stop, simply activate the draw-stop / tab or press [EXIT] to quit the function.
In both cases the set-up just created is saved automatically.
58
User Guide