Viscount UNICO 500 Guide De L'utilisateur page 47

User Guide
14. Pedal Board pistons.
This section contains the six pedal board combinations and the [HR] control for restoring the pedal
board voice setup prepared in manual mode before one of these combinations is recalled. These
combinations can be modified; the procedure for saving them is described in point 18.
15. Manual III pistons.
Pistons of the dedicated combinations of Man.III. [HR] for restoring the Man.III voices setup prepared
in manual mode before one of these combinations is recalled. The combinations can be modified; the
procedure for saving them is described in point 18.
[P] of the III/P coupling.
[M.SOLO] (MIDI Solo) piston, which allows mono transmission of the notes played on this manual on
the MIDI [OUT] output, with priority to the highest note.
16. Manual II pistons.
Pistons of the dedicated combinations of Man.II. [HR] for restoring the Man.II voices setup prepared in
manual mode before one of these combinations is recalled. The combinations can be modified; the
procedure for saving them is described in point 18.
[P] of the II/P coupling. [III] and [I] of the keyboards couplings (Unico 500 and 400 only).
Unico 500 and 400 models also have the [O.SOLO] (Organ Solo) pistons, which allow the Man.III
voices to be played in mono mode with priority to the highest note when the III/II coupling is active, and
the [M.SOLO] (Midi Solo) piston, which allows mono transmission of the notes played on this manual
on the MIDI [OUT] output, with priority to the highest note.
17. Manual I pistons.
Pistons of the dedicated combinations of Man.I. [HR] for restoring the Man.I voices setup prepared in
manual mode before one of these combinations is recalled. These combinations can be modified; the
procedure for saving them is described in point 18.
[P] of the I/P coupling. [III] (Unico 500 and 400 models) or [II] (Unico 300 model) of the keyboards
coupling.
Unico 500 and 400 models also have the [M.SOLO] (MIDI Solo) piston, which allows mono transmission
of the notes played on this manual on the MIDI [OUT] output, with priority to the highest note.
18. [S] Piston.
Fixing piston for saving the general and dedicated combinations, the Tutti and the Crescendo steps.
To set a combination or the Tutti, after setting the voices as required, press [S], hold it down and then
press the piston or foot piston of the combinations you wish to save.
To save a Crescendo step, select it using the pedal of the same name, press [S], hold it down and press the
[HR] of the general memories. To copy the contents of one step into another, select the step you wish to
copy, hold down the [S] piston, select the step into which you wish to copy the contents, then press the
[HR] of the general memories.
NOTE
If the LED of the [S] piston is off, programming of the organ is locked out by the Lock Organ
function (chapt. 10), so it will not be possible to save combinations and/or view internal programming
functions.
19. Organ general controls.
These controls do not refer to individual sections but to the entire instrument.
- [MEM. BANK +] and [MEM BANK -]: they select the memory bank displayed by the additional
[MEM. BANK] display (point 12).
- [ENC]: enables the Enclosed function, which allows the organ's general volume to be controlled
Viscount
45
UNICO 500 - 400 - 300