Sharpening With Powersharp - Oregon CS250 Manuel D'instruction

SHARPENING WITH POWERSHARP®
SHARPENING WITH POWERSHARP®
WARNING: POWERSHARP®
SHOULD NOT BE USED IN THE
PRESENCE OF EXPOSED, EXTREMELY
FLAMMABLE MATERIALS SUCH AS
PETROL AND ACETYLENE.
CAUTION: SHARPENING WITH THE
POWERSHARP® SYSTEM PRODUCES
LOW ENERGY SPARKS.
INTRODUCTION TO
POWERSHARP®
This chain saw is equipped with the
PowerSharp® integrated sharpening
system, a fast and easy way to sharpen
chain on the saw It is time to sharpen the
saw chain when cuts take longer or the
wood chips become smaller, in extreme
cases turning to saw dust
OPERATION
IMPORTANT: THE POWERSHARP®
INTEGRATED SHARPENING
SYSTEM IS FOR USE ONLY WITH
POWERSHARP® CHAIN. NEVER
ATTEMPT TO SHARPEN OTHER
CHAIN WITH THE INTEGRATED
SHARPENER. DAMAGE TO THE CHAIN
AND SHARPENER WILL OCCUR.
IMPORTANT: POWERSHARP® CHAIN
USES UNIQUE TOP-SHARPENING
CUTTERS AND CAN ONLY BE
SHARPENED WITH A GENUINE
POWERSHARP® SHARPENER.
24
OREGON® CORDLESS TOOL SYSTEM
CHAIN SAW MODEL CS250
• With the saw at full speed, lightly lift
the PowerSharp® lever for 3–5 seconds
(Fig 24) Sparks will be visible when the
cutters are in contact with the
sharpening stone
FIG. 24
• Make a test cut to determine if the chain
has been sufficiently sharpened If not,
repeat the sharpening procedure until
the chain is sufficiently sharp
IMPORTANT: DO NOT APPLY TOO
MUCH FORCE WHEN SHARPENING.
EXCESSIVE FORCE CAN REDUCE
THE PERFORMANCE OF THE
SHARPENING STONE.
IMPORTANT: IT IS NORMAL TO SEE
A SMALL AMOUNT OF SPARKS AND
SMOKE DURING SHARPENING AS
THE CUTTERS CONTACT THE STONE
AND FRICTION HEATS THE CHAIN.
WHEN TO REPLACE THE
SHARPENING STONE
The sharpening stone is designed to wear
at the same rate as the chain Always
replace the stone when replacing the
chain, even if it appears to have more life
See "Replacing the Sharpening Stone" in
this manual
AD 0213 - F/N 551309