Sharpening With Powersharp; Sharpening The Chain - Oregon CS300 Manuel D'instruction

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING THE SAW
SHARPENING WITH
POWERSHARP®
WARNING: POWERSHARP® SHOULD
NOT BE USED IN THE PRESENCE OF
EXPOSED, EXTREMELY FLAMMABLE
MATERIALS SUCH AS GASOLINE AND
ACETYLENE.
CAUTION: SHARPENING WITH THE
POWERSHARP® SYSTEM PRODUCES
LOW ENERGY SPARKS.
CAUTION: THE POWERSHARP®
INTEGRATED SHARPENING SYSTEM IS
FOR USE ONLY WITH POWERSHARP®
CHAIN. NEVER ATTEMPT TO SHARPEN
OTHER CHAIN WITH THE INTEGRATED
SHARPENER. DAMAGE TO THE CHAIN
AND SHARPENER WILL OCCUR.
INTRODUCTION TO POWERSHARP®
This chain saw is equipped with the
PowerSharp® integrated sharpening
system, a fast and easy way to sharpen
chain on the saw . It is time to sharpen the
saw chain when cuts take longer or the
wood chips become smaller, turning the
wood chips into saw dust .

SHARPENING THE CHAIN

IMPORTANT: POWERSHARP® CHAIN
USES UNIQUE TOP-SHARPENING
CUTTERS AND CAN ONLY BE
SHARPENED WITH A GENUINE
POWERSHARP® SHARPENER.
28
OREGON® Cordless Tool System
CHAIN SAW MODEL CS300
• With the saw at full speed, lightly lift
the PowerSharp® lever for 3–5 seconds
(Fig . 41) . Sparks will be visible when the
cutters are in contact with the
sharpening stone .
FIG. 41
• Make a test cut to determine if the chain
has been sufficiently sharpened . If not,
repeat the sharpening procedure until
the chain is sufficiently sharp .
IMPORTANT: DO NOT APPLY TOO
MUCH FORCE WHEN SHARPENING.
EXCESSIVE FORCE CAN REDUCE THE
PERFORMANCE OF THE SHARPENING
STONE.
IMPORTANT: IT IS NORMAL TO SEE
A SMALL AMOUNT OF SPARKS AND
SMOKE DURING SHARPENING AS THE
CUTTERS CONTACT THE STONE AND
FRICTION HEATS THE CHAIN.
WHEN TO REPLACE
THE SHARPENING STONE
The sharpening stone is designed to wear
at the same rate as the chain . Always
replace the stone when replacing the
chain even if it appears to have more life .
See "Replacing a Worn Saw Chain and
Sharpening Stone" in this manual .
AA 1214 - F/N 573259

Publicité

Table des Matières
loading

Table des Matières