Filling A Pd-Tip - BRAND HandyStep S Mode D'emploi

The volumes listed in the table are the only options possible. Since the
first dispensing step must be discarded, the number listed in the table is
always 1 step less.

5.3 Filling a PD-Tip

a.
b.
9974 63
NOTICE
We recommend priming a new PD-Tip
before use. To do this, fill the tip with a
minimal amount of liquid and empty it
again. Small air bubbles in the area of
the piston after priming do not affect the
results.
a.
Push the locking/filling lever to the
lower stop.
b.
Immerse the head of the PD-Tip verti-
cally into the liquid 3 - 10 mm.
5 Operation
NOTICE
Operating manual
39