How To Set The Time - Angelcare AC315 Manuel De L'utilisateur

1
INFO BAR IMPORTANT ICONS
Wired
Sensor Pad
Normal Status
Sensor Pad
is Paused
Sensor Pad
Alert
Sensor Pad
Lost Link
4.1 ‑ HOW TO SET THE DATE
When activating the Parent Unit for the first time, you'll be asked to set the date and time
in order to record movement & temperature data. If you choose to skip this step, you can
always go back later by accessing the settings menu
3
02:04 18°C
12/31/2016 31/12/2016
/ /
08 22
4
4.2 ‑ HOW TO SET THE TIME
3
02:04 18°C
02 04
4
68
241AC_10_AC315_EU2_M2.indd 68
1) Press and hold the Parent Unit ON/OFF button for
2 seconds until LCD screen is turned ON. Angelcare's
logo will be shown for 1 second.
When Parent Unit is turned ON and Camera is OFF, Parent Unit will display
Out‑of‑Range icon.
If there is a lost connection between the two units after 15 seconds, the Out‑of‑Range
alarm will sound on the Parent Unit (refer to Troubleshooting section):
• The Out‑of‑Range icon will appear on the screen and on the info bar.
Camera
displaying image
and sound
"TIC" icon
Temperature
VOX icon
alerts icons
1) Press
1
Day/Month/Year display.
2) Press the down arrow
3) Set the day with the up/down arrows
2016 confirm with
and confirm with
4) Press the down arrow
2 is highlighted in blue then Press the
the settings.
1) Press
1
2) Press the down arrow
3) Set the hours with the up/down arrows
confirm with
pm display and confirm with
4) Press the down arrow
is highlighted in blue then Press the
2
the settings.
The Camera connection signal strength
icon will appear in the status bar.
Volume Level
icons
Reception
Quality icons
Too Cold
Too Warm
Out‑of‑Range
.
to switch between Month/Day/Year and
once and then
. Do the same for the month and year
.
, the Save icon at the bottom
to switch between 12 h and 24 h mode.
once and then
. Do the same for the minutes and am/
, the Save icon at the bottom
Battery Level
indicators
Fully charged
battery (only
appears when
Parent Unit is
plugged in
to set the date.
and
button to save
to set the time.
and
.
button to save
2018-02-26 1:34 PM