D. Setup
CAUTION
Before operating the icemaker, the bin control
assembly must be installed correctly. Failure to
properly install the assembly could result in ice
backup and unit damage.
1) Follow the storage bin's setup procedure.
2) Position the storage bin in the selected permanent
location.
3) Place the icemaker on top of the storage bin.
4) Secure the icemaker to the storage bin using the
2 mounting brackets and the bolts provided. See Fig. 2.
Icemaker
Bin
Fig. 2
5) Install the bin control assembly as follows:
a. Remove the baffle from the storage bin.
b. Remove the thumbscrew and bin control assembly
from inside the icemaker. See Fig. 3.
Bin Control Assembly
Thumbscrew
Fig. 3
Bolts
Mounting
Brackets
c. Use the thumbscrew removed in the previous step
and the thumbscrew included in the accessory bag to
secure the bin control assembly to the bottom of the
icemaker. See Fig. 4.
d. Remove the bin control cable bracket from inside the
icemaker, then route the bin control cable through
the hole in the bin control bracket and the hole in the
bottom of the icemaker. Route the cable through the
bushing in the bin control cable bracket, then secure
the bracket. Leave as little slack as possible inside the
storage bin. Route the cable through the wire saddles.
e. Connect the bin control cable connector to wire
harness connector A coming from the control box.
Note:
1. Wire harness has one connector to plug into the bin
control cable and another connector for use if an
upper unit is installed.
2. Wire harness is connected to the control board red
K4 connector.
f. Make sure the bin control cable and wire harness are
secured in the wire saddles and do not interfere with
any components.
Connection Overview
Bin Control Cable Connector/Wire Harness Connector A
Wire Harness Connector B
(for upper unit)
Bin Control Bracket
Bin Control Assembly
Thumbscrews
Connection Detail
Wire Harness Connector B
(for upper unit)
Bin Control Cable Connector
4
Wire Harness
Control Board Red
K4 Connector
Wire Saddle
Bin Control
Cable Bracket
Bin Control Cable
Wire Harness
Connector A
Control Board Red
K4 Connector
Fig. 4