Installation Of Upper Unit - Hoshizaki KM-1301S_J-E Notice D'installation

6) Level the icemaker and storage bin in both the left-to-
right and front-to-rear directions. Adjust the storage bin
legs to make the icemaker level.
7) Replace the panels and storage bin baffle in their
correct positions unless you are installing an upper unit.
If installing an upper unit, see "I.E. Installation of Upper
Unit."
E. Installation of Upper Unit
1) See "I.D. Setup" for the lower unit installation.
2) Remove the top panel and the top insulation of the
lower unit. The top panel and the top insulation of the
lower unit are not required when installing an upper unit.
3) Unpack the upper unit and remove the shipping carton,
tape, and packing material.
4) Remove the panels of the upper unit.
5) Stack the upper unit on top of the lower unit.
6) Secure the upper unit to the lower unit using the
2 mounting brackets and the bolts provided. See Fig. 5.
Icemaker
(Upper Unit)
Icemaker
(Lower Unit)
Bin
Fig. 5
7) Remove the bin control cable bracket from inside the
upper unit. See Fig. 6. Leave the upper unit's bin control
assembly in its original position. It will not be used.
8) Route lower unit wire harness connector B through the
hole in the bottom of the upper unit. Route the wiring
through the bushing in the bin control cable bracket,
then through the wire saddles.
9) Connect lower unit wire harness connector B to upper
unit wire harness connector A.
Note: Wire harness is connected to the control board
red K4 connector.
10) Make sure the wire harnesses are secured in the wire
saddles and do not interfere with any components.
11) Secure the bin control cable bracket.
12) Replace the panels and storage bin baffle in their
correct positions.
Bolts
Mounting
Brackets
5
Upper Unit Connection Overview
Lower Unit Wire Harness Connector B/
Upper Unit Wire Harness Connector A
Upper Unit Wire Harness
Connector B (not used)
Bin Control
Cable Bracket
Upper Unit Connection Detail
Upper Unit Wire Harness
Connector B (not used)
Lower Unit Wire Harness Connector B
See "I.D. Setup" for
Lower Unit Connection
Fig. 6
Upper Unit Wire Harness
Control Board Red
K4 Connector
Lower
Unit Wire
Harness
Wire Saddle
Control
Board
Red K4
Connector
Upper Unit
Wire Harness
Connector A
Control Board Red
K4 Connector