Before Machine Start-Up - Nilfisk Advance SC500 20D B Instructions D'utilisation

ENGLISH

BEFORE MACHINE START-UP

WARNING!
When starting the machine, or before operating the One-Touch push-button (43), make sure that there is no
foreign material between the deck and the tank assembly which could obstruct the deck movement. If the
machine has been turned off without lifting the deck, the deck would lift automatically at next machine start-up.
Brush or pad-holder removal/installation (Disc system)
1. According to the kind of cleaning to be performed, the
machine can be equipped either with the brush (A, Fig.
2) or the pad-holder (B) with pad (C) together with the
appropriate deck.
2. Place the brush (A) or the pad-holder (B) under the deck
(26).
3. Place the user key (52) in the key reader (41), then press
the push-button (42) to turn on the machine.
4. Press the turtle push-button (46) to reduce the driving
speed to idle.
5. Press the One-Touch push-button (43) to lower the deck
on the brush.
6. To engage the brush, press the paddle (2), then release
it. If necessary, repeat the procedure until the brush is
engaged.
CAUTION!
Turn the machine speed to idle and slightly press
the paddle, otherwise the machine starts to
move.
7. To remove the brush, the deck must be lifted by pressing
the One-Touch push-button (43), then press the release
push-button (44).
When the display shows the
brush is lowered onto the floor.
Available brushes and their relevant application guides (suggestions only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
12
INSTRUCTIONS FOR USE
icon (51), wait until the
46 GRIT 80 GRIT
SC500 - 9099980000
180 GRIT 240 GRIT 500 GRIT
revised 07/2017
A
B
C
Figure 2
PROLENE PROLITE
P100842
UNION MIX
11/2014