Before Machine Start-Up - Nilfisk SCRUBTEC 545B Instructions D'utilisation

05/2015

BEFORE MACHINE START-UP

Brush or pad-holder installation/removal (for SCRUBTEC 545B - 545BL - 553B - 553BL)
1. According to the kind of cleaning to be performed, the machine can be equipped either with the brush (A, Fig. 2) or the pad-
holder (B) with pad (C) together with the appropriate deck.
2. Insert the ignition key (80) and turn it to "I".
3. If equipped, turn the speed adjuster (84) to idle by turning it counter-clockwise.
4. Place the brush (A) or the pad-holder (B) under the deck (18).
5. Lower the deck on the brush by pressing the pedal (11).
6. Turn the ignition key (80) to "I".
7. Press the One-Touch push-button (71).
8. Press one of the push-buttons (83) to engage the brush/pad-holder, then release it. If necessary, repeat the procedure until the
brush is engaged.
WARNING!
(Only for SCRUBTEC 545BL and 553BL): Turn the speed adjuster (84) counter-clockwise to drive the machine at
the minimum speed.
To engage the brush press one of the push-buttons (83) which turns on the brush/pad-holder motor.
9. To remove the brush, the deck must be lifted by pressing the pedal (11), then press the release push-button (75) and wait for
the brush to fall on the floor.
Turn the ignition key (80) to "0".
Types of brushes available and application guide (for SCRUBTEC 545B - 545BL - 553B - 553BL) (suggestions
only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
02/2007
Midlite Grit 180
9097054000 - SCRUBTEC 545B / 545BL / 553B / 553BL / BOOST 5
INSTRUCTIONS FOR USE
Figure 2
Midgrit 240 Prolene
ENGLISH
S311334
Prolite Union Mix
13