Priming Menu - DAB E.SWIM Instructions Pour L'installation Et La Maintenance

OUTPUT
STATUS
Useful page for verifying the correct
functioning of the connections.

5.8 PRIMING Menu

PRIMING
Each time the pump starts, the system performs the priming procedure (if enabled).
Priming consists of two phases:
- At the end of pump startup (as described in par. 3.2), the flow is checked; if it regular, Priming has already been
completed and it passes to the conditions of the active setpoint.
- If this is not the case, the system has discharged and must be primed again: it now enters the second phase, where
the pump is activated at Maximum Priming Speed, until it is primed or at any rate for all the time specified by the
parameter "Max Priming Time".
ENGLISH
PARAMETERS VALUES
Config RUN
FAULT
Type NO
NC
PARAMETERS DESCRIPTION
IN-0 Status of the digital Input
OUT Output relay status
AN Status of the Analog Input
AP ext Value of the enabled External Speed
IN1-4 Status of the inputs on EADAPT
PARAMETERS VALUES
Enable Yes/No
Speed 50%-100%
Time 1-30 min
68
DESCRIPTION
The relay signals when the pump is
working
The relay signals when the pump
fails
Normally open, the relay closes to
signal the change of status
Normally closed, the relay opens to
signal the change of status
DESCRIPTION
Enables or disables the Priming
function that occurs at each start. It is
usually disabled in installations below
water level.
Sets the maximum speed during
priming, which can be reduced in the
case of systems unable to withstand
high speeds.
Sets the duration time in the priming
phase.
At the end of this time, if priming has
been successful, it proceeds regularly
according to the active setpoint. But if
priming has not been successful, it
goes into "NoPriming" fault status
("Pump not primed" block). See
chapter 6.