Programming The Timers; Programming Of The Remote Control Or External Control - DAB E.SWIM Instructions Pour L'installation Et La Maintenance

5.6 Programming the Timers

TIMERS
There are eight different timers on the machine, from Timer A to Timer H, each of which allows timed starting and
stopping, on a weekly basis, of a setpoint chosen from Set Points 5-8.
With a simple setting you can thus automatically carry out all the desired cycles, repeated weekly.
SETTING OF THE TIMERS
Another special function is available: holding down "Enter" [
which you are positioned; moving to another timer and holding down "OK" [
configuration of the first timer onto this one; the operation is then confirmed by pressing "OK" [
pressing "ESC" [ ].
If two or more timers have been programmed as "active" at the same time, the one that comes first in
alphabetical order will have precedence, that is Timer A will have precedence over Timer B and so on.
DISPLAY TIMER TABLE

5.7 Programming of the Remote Control or External Control

EXTERNAL CONTROL MENU
From the External Control menu, the possibility of controlling the pump from the available external inputs is enabled.
In addition, a series of parameters are set to choose the input source, the pump operating mode (MASTER or SEMI-
MASTER/Override), the type of link with the set speeds (see Start Input, Speeds mode parameters) and the type of
input and output signal (normally open or closed).
SETTINGS
ENGLISH
PARAMETERS VALUES
the START time 00:01 - 23:59
the STOP time 00:01 - 23:59
Desired speed S5-S8
("S")
Lun / Dom
Days of the week
Enable Timer ("E") 1 min - 10 h
] for three seconds makes a copy of the timer on
DESCRIPTION
The set timers are displayed like a chrono-thermostat: the profile of the
set points used as a function of the time is shown for each day of the
week. This offers an immediate check of the operation of each whole
day.
PARAMETERS VALUES
Config Disabled
Enabled
Override
Origin speed 0-10 V
66
DESCRIPTION
sets the time of starting the work
cycle
sets the time of ending the work
cycle
Selects one of the 4 speeds for the
set work cycle
You can enable the work cycle for
the days of the week you want
The possibility of enabling or
disabling a timer may be useful, for
example, at the change of season,
allowing you to exclude a timer but
leaving all its data set to be used
again later.
] for three seconds pastes the whole
] or cancelled by
DESCRIPTION
External Control Disabled
External Control enabled and
Timers A-H disabled
External Control enabled with
priority over the enabled Timers A-
H
Speeds determined by 0-10V
analog voltage signal (see chapter
2.5)