DAB E.SWIM Instructions Pour L'installation Et La Maintenance page 69

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INPUTS
ENGLISH
4-20mA
X1
E.ADAPT
Start Input
IN-0
Speed
Speed Mode
Priority
Combinations a speed according to table X is
PARAMETERS
VALUES
IN0-IN4 Type
NO
NC
67
Speeds determined by 4-20 mA
analog current signal (see chapter
2.5)
The speed X1 set in the "External
Speeds" menu is implemented.
Speed determined by the status of
the inputs of the "E.ADAPT" module
(inputs configured with the "Speeds
Mode" parameter)
Starting of the pump is determined
by the status of input IN-0.
With E.ADAPT, IN-0 is the input 0
of the module;
without E.ADAPT, IN-0 is the status
of the digital input on the 5-pin
connector.
Pump starting determined by the
status of inputs IN1-4 of the
E.ADAPT module.
Without E.ADAPT it has no
meaning.
In case of Speed Mode = Priority,
speeds X1-X4 are available;
In case of Speed Mode =
Combination, speedsX1 is not
available.
Each input is associated with a
speed (IN1 --> X1; IN2 --> X2; etc.);
in the case of more than one
enabled input, the one with the
highest number (IN4>IN3>IN2>IN1)
has priority.
associated with each combination of
inputs IN1 and IN2
NOTE1: In case of Start Input =
Speeds, X1 is not enabled and the
combination 0 0 does not cause the
pump to start;
DESCRIPTION
Normally Open
Normally Closed

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

E.proE.swim svrs

Table des Matières