Technical Characteristics; Svrs Notes (Only Applicable To Model E.swim Svrs) - DAB E.SWIM Instructions Pour L'installation Et La Maintenance

1- User panel cover
2- User panel
3- QR code
4- Quick guide
5- Terminal board cover
6- External connector
7‐ Power cable inlet

1.2 Technical characteristics

The technical characteristics are summed up in the table below.
Topic
ELECTRIC POWER
SUPPLY
CONSTRUCTION
CHARACTERISTICS
HYDRAULIC
PERFORMANCE
WORKING
CONDITIONS

1.3 SVRS Notes (Only applicable to model E.SWIM SVRS)

The Safety Vacuum Release System (SVRS) model is designed to provide an additional layer of protection against body
suction entrapment. It complies with ASME/ANSI A112.19.17 -2010 SVRS standard.
1. SVRS devices shall only be installed in conjunction with an ASME A112.19.8 suction fitting, or a 12 in. x 12 in. (305
mm x 305 mm) drain grate or larger, or an approved channel drain system at each suction outlet or drain outlet.
2. Check valves and hydrostatic valves shall not be used in suction systems protected by SVRS devices.
WARNING
high vacuum present at the drain, even though the drain was protected by an SVRS device.
3. All SVRS devices shall be factory set or field adjusted to site -specific hydraulic conditions. Once installed, the system
shall be tested by simulating an entrapment event.
Parameter
Voltage
Frequency
Maximum current
Maximum power
Overall dimensions
Empty weight (excluding packaging)
Protection class
Motor insulation class
Maximum head
Maximum flow rate
Maximum working pressure
Max liquid temperature
Max ambient temperature
Table 1 – Technical Characteristics
– The presence of a hydrostatic valve in the suction piping has been shown to prolong the
ENGLISH
Figure 2
574 x 310 x 316 mm / 22.6 x 12.2 x 12.4 in
43
E-SWIM
220-240 V +/- 10%
50/60 Hz
5.6 SFA
1250 W
18 kg / 39 lb
IP55
F
16 m / 52 ft
32 m3/h / 141 gpm
2,5 bar
40°C / 104°F
50°C / 122°F