Animo M Série Mode D'emploi page 42

Symptom:
The coffee is too weak.
The coffee is not hot enough There is no lid on the jug.
The jug is too full or is
overflowing.
Not enough coffee is
getting into the jug.
E1 (filling time error).
E8 (minimum water sensor
fault) from software version
1.4
An E2, 3, 4, 5, 6, 7 appears
in the display and both indi-
cator lights flickers.
GB
Troubleshooting guide coffee making selection
Possible cause:
Not enough coffee has
been placed in the filter.
The water distributor is
soiled, so that the coffee
is not being completely
drenched.
The set quantity is too high.
The set quantity is too low.
Appliance fills too slowly.
The water supply is blocked
Reservoir does not fill
during the brewing process.
The control unit is reporting a
defect that can only be
resolved by a service technician.
Action:
Increase the amount of
coffee.
Unscrew the water distribu-
tor and clean it.
Use the lid.
Lower the quantity.
See chapter 5.1 Setting the
amount of coffee.
Increase the quantity.
See chapter 5.1 Setting the
amount of coffee.
Check the water supply.
Fully open the tap. Increase
the water pressure. Switch
the appliance on and off.
The error report will disap-
pear.
Contact dealer or service
technician.
37
M-LINE
2015/02 Rev. 4.0