Handsfree Calling; Connecting An Audio Device; Receiving Calls - Sony MEX-BT4000P Mode D'emploi

M:\081\XPML A7.0\ML\New Folder\4296017111_MEX-BT4000P_CaFR\01US-
MEXBT4000PU\01US02CD-U.fm
00ML+00COV-U.book Page 24 Friday, August 26, 2011 1:30 PM
Tip
With Bluetooth signal on: when the ignition is
turned to on, this unit reconnects automatically
to the last-connected cellular phone. But
automatic connection also depends on the
cellular phone's specification. If automatic
connection is not made, connect manually.

Connecting an audio device

1 Press  and rotate the control
dial until "SET BT SIGNL" appears,
then press it.
" " lights up when Bluetooth signal is
activated.
2
Turn on the audio device and activate
the Bluetooth signal.
3
Connect to this unit using the audio
device.
" " appears when the connection is
made.
Connecting the last-connected audio
device from this unit
1
Make sure the Bluetooth signal of the
cellular phone is activated.
Press  repeatedly until "BT
2
AUDIO" appears.
Press  (PAUSE).
3
" " flashes while the connection is
being made, then stays lit while
connected.
24

Handsfree calling

Once the unit is connected to the cellular
phone, you can make/receive handsfree
calls by operating this unit.
Before handsfree calling, check the
following:
 Make sure that " " and " " appear in
the display.
 If " " and " " do not appear, perform
the connection procedure (page 23).
 If you cannot connect this unit and the
cellular phone via the Bluetooth
function, perform the pairing procedure
(page 22).

Receiving calls

When receiving a call, a ringtone is output
from your car speakers or the connected
cellular phone. The caller's name or phone
number appear in the display.
1
Press (handsfree) when a call is
received with a ringtone.
The phone call starts.
Note
Depending on the cellular phone, the caller's
name may appear.
Rejecting a call
Press and hold  for 1
second.
Ending a call
Press (handsfree) again.
masterpage:Left
MEX-BT4000P
4-296-017-11(1)