Setting The Quantity Of Coffee In A Cup; Preparing Cappuccino - illy FrancisFrancis IPERESPRESSO X7.1 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
-
Insert the capsule holder in the brew head; turn the handle
to the right until it locks into place.
-
Check that the coffee button
-
Press and release the coffee button
brew the programmed quantity of coffee. To stop the fl ow in
advance, press the button again.
To make other coffees, remove the used capsule and repeat
the above steps.
Warning:
- The capsules are single-dose and cannot be used to
make two coffees.
- To ensure greater safety, the machine automatically
stops dispensing after approximately one minute.
- Remember to empty and clean the drip tray frequently.
SETTING THE QUANTITY OF
COFFEE IN A CUP
The X7.1 machine allows you to brew a pre-set quantity of
coffee. Just press the coffee brew button and the machine will
stop as soon as the stored quantity has been brewed. However,
if the quantity brewed is not the desired one, you can manually
set and store a new quantity of coffee.
19
is lit.
; the machine will
SETTING A NEW QUANTITY OF COFFEE:
- Insert a capsule into the capsule holder and secure it to the
coffee brew head.
- Place a cup beneath the capsule holder.
- Press the coffee brew button and keep it pressed.
- As soon as the desired quantity has been reached, release
the coffee brew button.
- The machine has now stored the new quantity of coffee.
You can also manually adjust the quantity of coffee for each
brewing, without having to change the stored settings, through
the manual brewing.
MANUAL BREWING:
- Press the coffee brew button for 3 seconds. The machine will
start brewing coffee.
- As soon as the desired quantity has been reached, press
again the coffee brew button to stop brewing.
- By following this procedure, the machine will not store the
brewed quantity and the coffee volume brewed will be only
for that specifi c brewing.

PREPARING CAPPUCCINO

The machine features a steam wand for frothing the amount of
milk necessary to prepare one or more cappuccinos.
Prepare one or more cups of coffee following the instructions
in the previous section.
Froth the milk as follows:
Press the steam button
steam icon in the central circle will
light up to signal that the machine
is getting ready to dispense steam.
EN
; the

Publicité

Table des Matières
loading

Table des Matières