In The Event Of A Malfunction; Improper Use Of The Machine - illy METODO IPERESPRESSO GOOD NEWS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Manuale ENG lay4:Layout 1 15/07/2009 10.36 Pagina 7
Check that the mains voltage is the same as the machine's
operating voltage indicated on the nameplate. Only connect the
appliance to a socket with a minimum output of 6 A with a
230 V supply and of 12 A with a 120 V supply and a regulation
earthing.
In the event that the socket and the plug on the appliance
are not compatible, arrange to have the socket replaced by a
qualified electrician.
Do not stand the appliance on a worktop close to taps or sinks.
Check that the appliance is working after you have removed it
from the packaging.
CLEANING
Remove the mains plug from the socket before cleaning the
machine.
Before pulling the mains plug out, make sure that the machine
is switched off.
Let the appliance cool down before cleaning.
Clean the housing and accessory parts with a damp cloth and
then rub dry with a cloth. We advise against using detergents.
Do not place the appliance under a jet of water or either wholly
or partially submerge it in water.
All manuals and user guides at all-guides.com

IN THE EVENT OF A MALFUNCTION

Do not use the appliance if it has been damaged or is
malfunctioning. Nor should it be used if the cable or plug is
damaged. Take the appliance to the nearest appointed dealer
for inspection and any repairs. Contact the manufacturer and
Customer Service for the replacement of damaged power
cables.
If the machine is damaged or malfunctioning, switch it off
immediately and do not attempt to dismantle it. For any
repairs, contact a manufacturer-approved service centre only
and ensure that original parts are used. Failure to follow these
instructions may affect the safety of the appliance and
invalidate the warranty.

IMPROPER USE OF THE MACHINE

This appliance is intended for domestic use only. Therefore,
it is dangerous to use it in any other way than the purpose for
which is intended.
The manufacturer is not liable for any accidents caused
by inadequate earthing or where this does not conform to
current legal requirements.
The manufacturer is not liable for any damage caused by
improper, incorrect or inappropriate use.
EN
7

Publicité

Table des Matières
loading

Table des Matières