Infl Ation Instructions; Using The Boat - Gumotex SAFARI 330 Manuel De L'utilisateur

3. Infl ation Instructions

Unfold the kayak. If you intend to use a tracking fi n, slide it
in the attachment in the bottom (17). Before you start in-
fl ating, unfold the kayak and install the seat and backrest,
fastening straps and footrest. Insert the backrest (8) into
the kayak between both backrest holders (13). Tie a sim-
ple knot on one end of the provided cord. Thread the other
end from behind through the lower backrest holder ope-
ning (13), lower backrest opening (8), eyelet at the end of
fastening strap (11) and back through the upper backrest
opening and holder opening. Tie a knot to fasten it. See de-
tail A. Repeat the steps on the opposite side of the backrest.
Thread the narrow end of the fastening strap through the
fastening strap holder (12) situated in the front section of the
kayak. Adjust the footrest (9) position according to your sta-
ture. The individual positions are marked with numbers on
the foot rest attachment (10). Position No. 1 corresponds to the
height of (150-160) cm, position No. 2 (160-170) cm, position No.
3 (170-180) cm, position No. 4 over 180 cm.
Run the foot rest strap through holes in the foot rest atta-
chment (10) on the bottom.
Proceed through all holes from the selected position up to
the plastic buckle at the end of the attachment; run the end
through it and tighten it. See detail B.
Inflate air chambers in the following sequence: seat (7),
backrest (8), footrest (9), side tubes (1), bottom (2). Use a
foot-pump or piston pump with valve adaptor for infl ating -
see Figure 2b (the adaptor is included in the glue set). Check
the condition of the valves before infl ating. Tighten the val-
ves with the assembly key - see Fig. 2c. Set the valves to the
OFF position. For valve operation see Figure 2.
Infl ate the air chambers until they are fi rm but not completely
stiff . The air chambers should provide a feeling comparable to
squeezing a ripe orange. You can check the exact operating
pressure by using a suitable pressure gauge (optional acce-
ssory) – see Figure 2a.
Sit inside the kayak after infl ating and check the position
of the foot rest. If you wish to correct the position of the
foot rest, release pressure in the bottom, release the foot
rest strap and infl ate again after correcting the position.
Then adjust the correct length of fi xation straps (11). Sit down
in the kayak again, prop your feet against the foot rest. Pull
the fi xation straps over your knees and fasten them tightly.
ATTENTION
The maximum operational pressure in air chambers
is 0.02 MPa. If the ambient temperature increases
(e.g. owing to sunlight), the pressure in the air chambers
of the boot can rise rapidly. We recommend releasing
some air from all air chambers of the boot after pulling it
out of the water. This will prevent possible destruction of
the air chambers. However, do not forget to continuous-
ly check air pressure in the chambers afterwards, too. A
corresponding reduction in operating pressure is up to
20 % within 24 hours.
ATTENTION
When using the boat, always seal the valves with their
valve caps. This will keep dirt out of the valves. Dirt can-
cause leaky valve seals.
10

4. Using the Boat

The SAFARI 330 single-seat infl atable kayak with self-
draining fl oor is designed for recreational use and water
tourism.
Whenever the kayak is used on waterways, Waterway Traffi c
Rules have to be observed. Operation of the SAFARI 330 in-
fl atable kayak does not require any licence provided that the
people who operate the kayak know the techniques of small
boat operation within the scope necessary for its operation,
as well as the valid navigation rules of the particular country.
The SAFARI 330 kayak can be used on rivers up to Di-
ffi culty Grade WW 3. This is only a recommended
use, it always depends on the specifi c abilities of the
user! Use double-bladed kayak paddle with a length
of (202–210) cm.
The person travelling in the kayak has to sit in their seat and
wear a fl otation life-jacket.
A good contact of the paddling person with the boat in
a sports-style kayaking, especially when performing eskimo
rescue, is provided by fi xation straps and the foot rest. The
centre of gravity can be lowered by releasing pressure from
the seat cushion, thus increasing the stability of the kayak
and a confi dence in performing the roll.
The manufacturer recommends using the boat in suffi -
cient water condition (see Control table - draught).
ATTENTION
Prior to using the kayak, check whether it is necessary
to observe any special regulations, restrictions or rules
connected with the river, surface of water or area in
which you intend to use it.
The boat is not intended for towing a motor boat, it must
not be slipped or otherwise excessively stressed. In case
of emergency, use the handle to at bow of the boat to
tow. Sharp edged or pointed items carried in the kay-
ak should be safely wrapped. Place all valuables into
a waterproof container and fasten it to the kayak. Over
time, sunlight adversely aff ects the rubber coating of the
boat; therefore, it is advisable to store the boat in shade
each time after use.
CAUTION:
• Releasing the fi xation straps and leaving the boat after
capsize must be well trained in calm water!
• On large surfaces of water (seas or lakes), pay attention to
water currents and off -shore breezes. Currents and bree-
zes may make it impossible to return to shore.
• The SAFARI 330 kayak should not be used in challenging
conditions, such as in decreased visibility (night, fog or
rain).
Characteristics of Diffi culty Grade WW 3 – Hard:
• Big rapids, high and irregular waves, pillows, whirlpools,
medium blockage and low cascades in strongly meande-
ring rivers or blind rivers.
ATTENTION
Pay great attention to your choice of fl otation life-jacket. Pay great attention to your choice of fl otation life-jacket.
The fl otation life-jacket should have a tag bearing details The fl otation life-jacket should have a tag bearing details
of its fl otation capabilities and safety certifi cation. of its fl otation capabilities and safety certifi cation.