Dometic WAECO CoolAir CA8505 Notice D'utilisation page 29

CoolAir
6.2 Switching on the stationary air conditioner
Caution
a
Never close all of the air nozzles of the stationary air conditioner
simultaneously. The device would ice up inside.
Note
I
The first time the stationary air conditioner is used, there may be a
slight smell. This is normal and soon goes away.
➤ With the system switched off, press the ON/OFF button (fig. 2 1,
page 3).
Note
I
If you completely switch off the stationary air conditioner, it can only
be switched on again using the control panel. The system can only
be switched on using the remote control if it is in standby mode, in
other words switched off using the remote control. If the system is
not going to be used for a lengthy period, switch it off completely so
that the battery is not wasted supplying standby power.
✓ The fan starts at low speed.
✓ The Power LED (fig. 2 8, page 3) lights up.
✓ The digital display (fig. 2 5, page 3) shows the target temperature in °C
and the operating mode (e.g.
20 °C).
Note
I
The compressor is switched on after a 90-second delay.
Using the stationary air conditioner
A20
for automatic mode + temperature
29