Cable Assembly; Putting Into Operation - Abicor Binzel ABIROB A Mode D'emploi

®
ABIROB A
5.3 Bracket

5.4 Cable assembly

6 Putting into operation

The bracket is used to attach the ABIROB
via the CAT robot mount.
The air-cooled cable assembly provides the welding torch with all the
components required for welding, e.g. the welding current, shielding gas and
air.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Disconnect the mains plug.
NOTICE
• Please take note of the following instructions:
 3 Product description on page EN-6
• The system may only be installed and put into operation by qualified
personnel (in Germany see TRBS 1203).
6 Putting into operation
®
A welding torch system to the robot
EN - 11