Setting Mode - Zanussi ZDT111 Notice D'utilisation

Setting mode

The appliance is in setting mode when all
programme lights are off and End of pro-
gramme light flashes.
IMPORTANT!
Always remember that when performing oper-
ations such as:
• selecting a washing programme
• setting the water softener
• deactivation/activation of the audible signals
Half load button
Programme selection/cancel button
the appliance MUST be in setting mode.
If a programme light is illuminated and End of
programme light is illuminated with fixed light,
the last performed programme is still set.
In this case the programme has to be cancelled:
1. Press and hold the Programme selection/
Cancel button until the light of the running
programme turns off and the End of pro-
gramme light is flashing.
2. Release the Programme selection/Can-
cel button.
The option must be linked to the selection of a washing
programme. (See "Programme table" chart). When
selected, the corresponding light illuminates.
Load dishes in both baskets (lower and upper).
When using the option reduce the dosage of detergent
which is normally used for a complete load.
• Starting the washing programme:
1. Press the On-Off button.
2. Press the Programme selection/cancel button
once, the light of the last performed washing pro-
gramme illuminates and the End of programme
light flashes.
3. Press the Programme selection/cancel button
as many times as necessary to illuminate the light
corresponding to the desired programme.
4. Close the dishwasher's door, the programme will
start automatically.
IMPORTANT!
Once the programme has started, if you want to
change the selection made you must cancel the wash-
ing programme in progress.
• Cancel the washing programme in progress:
1. Open the door.
2. Press and hold the Programme selection/cancel
button until the light of the running programme
5