Programme Selection Buttons; Digital Display; Function Buttons; Setting Mode - Zanussi ZDF4010 Notice D'utilisation

End-of-programme
Multitab
1)
Salt
1)
Rinse aid
1) When the salt and/or rinse aid containers are empty, the related indicator lights do not come on while a washing programme
operates.

Programme selection buttons

With these buttons you can select the washing pro-
gramme. Press a programme button, the related indica-
tor light comes on. Refer to 'Washing programmes' chap-
ter for more data about the washing programmes.
Delay start button
Use the delay start button to delay the start of the wash-
ing programme with an interval between 1 and 19
hours. Refer to the chapter 'Setting and starting a wash-
ing programme'.

Digital display

The display shows:
• the set level of the water softener.
• Remaining time to the end of the programme.
• Activation/deactivation of the rinse aid dispenser (on-
ly with multitab function on).
• End of the washing programme. The display shows a
zero.
• Number of hours in delay start.
• Fault codes.

Function buttons

Use the function buttons for these operations:
• To set the water softener. Refer to the chapter 'Setting
the water softener'.
4
Indicator lights
Comes on when the washing programme is completed.
Comes on when you activate the multitab function. Refer to 'Multitab function'.
Comes on when it is necessary to fill the salt container. Refer to 'Use of dishwash-
er salt'.
After you fill the container, the salt indicator light can continue to stay on for some
hours. This does not have an unwanted effect on the operation of the appliance.
Comes on when it is necessary to fill the rinse aid container. Refer to 'Use of rinse
aid'.
• To cancel the washing programme in progress or a
delay start in progress. Refer to the chapter 'Setting
and starting a washing programme'.
• To activate/deactivate the multitab function. Refer to
the chapter 'Multitab function'.
• To deactivate/activate the rinse aid dispenser, when
multitab function is active. Refer to the chapter 'Mul-
titab function'.

Setting mode

The appliance must be in setting mode for these
operations:
• To set a washing programme.
• To set the water softener level.
• To deactivate/activate the rinse aid dispenser.
Press the on/off button. The appliance is in setting
mode when:
– All the programme indicator lights come on.
Press the on/off button. The appliance is not in setting
mode when:
– Only one programme indicator light comes on
– A washing programme is set. It is necessary to can-
cel the programme to go back to the setting mode.
Refer to the chapter 'Setting and starting a washing
programme".