Function Buttons; Setting Mode; Audible Signals - Zanussi ZDT311 Notice D'utilisation

1) The indicator light is off while a washing programme operates.

Function buttons

Use the function buttons for these operations:
• To set the water softener. Refer to the chapter 'Setting
the water softener'.
• To deactivate/activate the audible signals. Refer to the
section 'Audible signals'.
• To activate/deactivate the multitab function. Refer to
the chapter 'Multitab function'.
• To deactivate/activate the rinse aid dispenser when
multitab function is active. Refer to the chapter 'Mul-
titab function'.
• To cancel the washing programme in progress or a
delay start in progress. Refer to the chapter 'Setting
and starting a washing programme'.
Delay start button
Use the delay start button to delay the start of the washing
programme with an interval of 3, 6 or 9 hours. Refer to
the chapter 'Setting and starting a washing programme'.

Setting mode

The appliance is in setting mode when all the programme
indicator lights are on.
The appliance must be in setting mode for these opera-
tions:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
– To deactivate/activate the rinse aid dispenser.
If a programme indicator light is on, cancel the pro-
gramme to go back to the setting mode. Refer to the
chapter "Setting and starting a washing programme".
20
Indicator lights
The indicator light comes on when the washing pro-
gramme is completed. Auxiliary functions:
• Level of the water softener.
• Activation/deactivation of the audible signals.
• Activation/deactivation of the rinse aid dispenser.
• An alarm if the appliance has a malfunction.

Audible signals

You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the
indicator lights of function buttons A, B and C start
to flash.
4. Press the function button C.
– Indicator lights for function buttons A and B go
off.
– Indicator light for function button C starts to flash.
– The end indicator light comes on.
The audible signals are activated.
5. Press the function button C again.
– The end indicator light goes off.
The audible signals are deactivated.
6. Switch off the appliance to save the operation.
Do these steps to activate the audible signals:
1. Do the above procedure until the end indicator light
comes on.