Maintenance - Hendi 210215 Mode D'emploi

7. MAINTENANCE

7.1 GENERAL FEATURES
Before starting maintenance it is necessary to:
• Disconnect the power supply cord plug from the
socket to isolate the slicer from the electric cir-
cuit completely.
7.2 BELT
The belt is not to be adjusted. Generally, it must be replaced after 3 or 4 years; in this case please call your
authorized "SERVICE CENTER".
7.3 FEET
Feet may deteriorate and lose elasticity, thus reducing the stability of the slicer. In this case they must be
replaced. Call your authorized "SERVICE CENTER" to replace the feet.
7.4 POWER SUPPLY CORD
EN
Periodically check the power supply cord for any symptoms of worn-out and, if this is the case, please call the
"SERVICE CENTER" to have it replaced.
7.5 BLADE
Check that the blade does not lose more than 10mm of its original diameter. To have it replaced call the
"SERVICE CENTER".
7.6 SHARPENER - GRINDING MOLES
Check that the grinding moles retain their abrasive property during sharpening operations. Call the "SERVICE
CENTRE" if it is necessary to replace the grinding moles to prevent the blade damage.
7.7 LUBRICATION OF SLIDING GUIDES
From time to time pour some oil drops onto the round sliding guide along which the carriage moves back and
forth. This operation can be performed through the opening (OIL) next to the dial knob.
14
• Place the dial knob adjusting the thickness plate
in the "0"position.