ROBBE POWER PEAK ULTIMATE Notice D'utilisation page 16

Notes
- The maximum charge and discharge currents vary according to the number of cells in
the pack.
- Don't end the charge or discharge process simply by disconnecting the battery pack;
always stop the process by pressing the MODE button.
- Lead-acid batteries can only be charged in manual mode.
Mains PSU
- If you use the Power Peak 7A mains PSU, Order No. 8415, the charger can also be ope-
rated from the 230 Volts mains supply, turning it into a universal 230 V AC and 12 V DC
charger. Note that the maximum currents are restricted in this mode of operation when
used with high cell counts.
Notes on RID (Radio Interference Directive)
In order to satisfy the conditions of the RID, the charge lead must be modified using the fer-
rite ring as shown in the sketch before you use the charger for the first time.
robbe Modellsport GmbH & Co. KG
We reserve the right to alter technical specifications.
Operating instructions
POWER PEAK ULTIMATE
ferrite ring
16
charge lead
Order No.
8427