Publicité
Les langues disponibles
Les langues disponibles
-
Press the START button to initiate the selected process.
-
The screen displays capacity, time, voltage and current. The status (C=CHARGE,
D=DISCHARGE, F=FINISHED) is displayed at top left of the screen.
Status
Voltage
-
The charge or discharge process is ended by the automatic termination circuit or by the
operator pressing the STOP button.
MANUAL MODE
Before you can start the actual charge or discharge process, you have to set the battery
type (NICD, NIMH or PB), the cell count, the battery capacity, the charge current and the
discharge current.
Up to ten such sets of parameters can be stored in spot memories 0 to 9 and called up at
any time. The setup menu required for this appears immediately when you select manual
mode.
Note: you can only change values in the first line when the arrow symbol is flashing.
MEMORY SELECT
BAT. TYPE
BAT. TYPE
NICD<-
BAT. CELL.
21 CELL
BAT. CELL. 21 CELL<-
BAT. CAP.
1800mAh
BAT. CAP.
1800mAh<-
CHAR. CUR.
CHAR. CUR.
4.5 A<-
DISC. CUR.
DISC. CUR.
2.5 A<-
EXIT
Operating instructions
POWER PEAK ULTIMATE
C 298mAh
31 . 55 V 3 . 80Aauto
Selecting the spot memory: Select the MEMORY SELECT
0<-
menu with the + button, confirm with ENTER, select the desi-
NICD
red spot memory with the +/- buttons and confirm with
ENTER. See also the section "Selecting a spot memory".
Selecting the battery type: Select BAT. TYPE with the + but-
ton, select the type with ENTER.
Entering the cell count: press the + button to select BAT.
CELL, confirm with ENTER. Set the cell count with the +/-
buttons and confirm with ENTER.
Entering the battery capacity (BAT. CAP): same method as
entering the cell count.
4.5 A
Entering the charge current (CHAR. CUR.): same method
as entering the cell count.
2.5 A
Entering the discharge current (DISC. CUR.): same
method as entering the cell count (PB: not available).
Capacity
0 : 05 : 29
Current
12
Order No.
8427
Time h : min : s
Automatic mode
Publicité
