ROBBE POWER PEAK ULTIMATE Notice D'utilisation page 14

↔
CHAR. 1990mAh
DISC. 1720mAh
↔
CHAR. 0 : 17 : 35
DISC. 1 : 47 : 21
0 ] NICD 21 CL 1800
↔
C: 4.5 A D : 2.5 A
Error messages
The following error messages can be erased by pressing any button once you have elimi-
nated the problem.
+++ OVERLOAD +++
+++ PROTECT +++
INPUT POWER
LOW VOLTAGE
OUTPUT BATTERY
CONNECT ERROR
OUTPUT BATTERY
REVERSE POLARITY
OUTPUT BATTERY
SHORT CIRCUIT
OUTPUT BATTERY
LOW VOLTAGE
OUTPUT BATTERY
OVER VOLTAGE
INPUT POWER
OVER VOLTAGE
TEMPERATURE
SENSOR ERROR
Operating instructions
POWER PEAK ULTIMATE
Charged-in or discharged capacity
Charge or discharge time
Spot memory, cell count, capacity, charge current and
discharge current
Charger overloaded; allow to cool down.
Power supply voltage less than about 9.5 V.
Check connection between battery pack and charger.
Battery connected with reverse polarity; check connections.
Short-circuit at charger output; check connections.
Battery pack voltage too low; check cell count setting.
Battery pack voltage too high; check cell count setting.
Input voltage higher than about 15.5 V.
Problem with temperature sensor. If this error recurs, consult
the robbe Service Department.
14
Order No.
8427