Publicité
Les langues disponibles
Les langues disponibles
Introduction
The POWER PEAK ULTIMATE is designed for charging and discharging NICD and NIMH
batteries consisting of 1 to 25 cells, both in automatic mode with automatic current setting,
and in manual mode. The charge process is terminated by the Delta Peak method when the
battery is fully charged.
The unit can also charge lead-acid batteries (2 to 12 Volts) automatically.
The charger features 10 spot memories in which you can store settings which you have
entered for each battery in manual mode.
Safety notes
-
If the charger is not to be used for a protracted period, disconnect it from the power
source and remove any battery packs connected to it.
-
Be sure to keep the cooling slots unobstructed to provide good air circulation - don't
stand the charger on a carpet or felt surface.
-
Do not set up the charger and batteries on a flammable surface, and never leave the
unit operating unsupervised.
-
Protect the unit from damp.
-
Take care to maintain correct polarity at all connections and outputs.
-
Avoid short-circuits.
-
Don't subject the charger to direct sunshine, and do not cover it.
-
Do not charge batteries which are already hot; allow them to cool down to ambient tem-
perature before recharging.
-
Use only packs of fast-charge cells which have been properly balanced (equal state of
charge).
-
Packs must consist of cells of the same make, type and capacity.
-
Do not wire two packs together in parallel for charging.
-
The unit is only suitable for use with rechargeable batteries.
-
Set charge currents within the maximum rated capacity of the cables and connectors
attached to the battery pack.
-
Never connect any charger output to the input.
Specification
Operating voltage:
Current drain:
Nominal battery voltage:
Fast-charge current
Trickle charge current:
Automatic charge termination: Delta Peak process / lead-acid process
Discharge termination:
Operating instructions
POWER PEAK ULTIMATE
approx. 10 V ... 15 V DC
12 V lead-acid battery or a powerful well stabilised mains
PSU (do not use a car battery charger!)
max. approx. 14 A
1.2 V ... 30.0 V (1 ... 25 NICD / NIMH cells,
2V ... 12 V lead-acid)
0.1 ... 5 A, voltage-dependent; see table
(approximate values)
max:
none
automatic, at approx. 0.8 V / cell (NICD and NIMH only)
10
3V
6V
9V to 20V
2A
3A
Order No.
8427
40V
5A
3A
Publicité
