Parkside PSBSA 20-Li C3 Traduction Des Instructions D'origine page 22

GB IE
e) Look after the power tool and
application tool carefully. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have
the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
h) Keep handles and grip surfaces
dry, clean and free from oil and
grease. Slippery handles and grip
surfaces do not permit safe operation
and control over the power tool in un-
expected situations.
5) CAREFUL HANDLING AND USE
OF BATTERy DEVICES
a) Charge the batteries only in
chargers that are recommended
by the manufacturer. Risk of fire if
a charger that is suitable for a specific
type of battery is used with other bat-
teries.
b) In the power tools, use only the
batteries designed for the pur-
pose. The use of other batteries may
result in injuries and risk of fire.
c) Keep the unused battery away
22
from paper clips, coins, keys,
nails, screws and other small
metal objects, which could
cause bridging of the contacts.
A short circuit between the battery con-
tacts may cause burns or fire.
d) If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event of
accidental contact, rinse off with
water. If the liquid gets into eyes,
seek medical assistance. Leaking bat-
tery fluid may cause skin irritations or
burns.
e) Do not use damaged or altered
batteries. Damaged or altered bat-
teries can be unpredictable and lead
to fire, explosion or risk of injury.
f) Do not expose batteries to fire
or elevated temperatures. Fire or
temperatures over 130 °C can cause
an explosion.
g) Follow all instructions for charg-
ing and never charge the bat-
tery or the battery-powered
tool outside the temperature
range stated in the operating
instructions. Incorrect charging or
charging outside the permitted tem-
perature range may destroy the battery
and increase the risk of fire.
6) SERVICE
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
b) Never repair damaged batter-
ies. All battery repairs should be car-
ried out by the manufacturer or author-
ised customer service centres only.